Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands

Expand Configuration and Management Manual — 529522-013

14 - 110

Considerations

For cause, effect, and recovery information for the event numbers generated by the

Expand subsystem, see the Operator Messages Manual.

Considerations

You can display the status information for several lines with a single STATUS LINE

command by specifying multiple LINE objects using parentheses as:

LINE ( line-name , line-name [ , line-name ] ... )

Examples

This SCF command summarizes the status on line $LINE1:

-> STATUS LINE $LINE1

This SCF command gives a detailed display of the status on path $LINE1:

-> STATUS LINE $LINE1, DETAIL

This SCF command summarizes the status on paths $LINE2 and $LINE3:

-> STATUS PATH ($LINE2,$LINE3)

ATM LIF error, error nnn 28

ATM LIF not found 29

ATM LIF is stopped 30

ATM LIF access state is down 31

ATM LIF inaccessible

Table 14-7. Messages and Corresponding Event Numbers (page 2 of 2)

Message Event Number