Expand Configuration and Management Manual (H06.21+, J06.10+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual — 529522-013
14 - 116
Considerations
TO file-spec
file-spec specifies the file to which tracing is to be initiated. The file might have
been previously created by you as an unstructured file with file code 0.
WRAP
causes the trace segment data to wrap instead of stopping the trace when it
reaches the end of file. The default is FALSE.
STOP
discontinues the trace currently in progress.
Considerations
•
Unless otherwise instructed by your HP representative, select all the trace record
types. This is the default.
•
The PROCESS name of the network control process is always $NCP.
•
The keyword L0 applies to both LINE and PATH objects. When L0 is used with
LINE, all frames sent and received on that line are traced. When L0 is used with
PATH, all frames for which this system is either the source or the destination are
traced in the PATH trace.
•
The keyword ALL selects all mask bits.
•
Selecting a keyword that does not apply to the object type specified has no effect.
•
All keywords apply when the object is a single-line path. For keyword L0, it is
handled as a LINE object.
•
You can trace several objects with a single TRACE command by specifying
multiple objects using parentheses as:
PATH ( path-name , path-name [ , path-name ] ... )
LINE ( line-name , line-name [ , line-name ] ... )
4 System abort messages 6
L5 5 Security events 198
ALL 0-31 Sets all 32 bits
Table 14-10. PATH Object Trace Records (page 2 of 2)
Mask Trace Record
Keyword Bits Meaning Type (decimal)
*Applies only to paths not attached to a ServerNet wide area network (SWAN) concentrator.