Expand Configuration and Management Manual (H06.21+, J06.10+)

About This Manual
Expand Configuration and Management Manual—529522-013
xxxv
Part III Contents
Part III Contents
Part III, Subsystem Control Facility (SCF), consists of Sections 14 and 15. Table iii
summarizes the contents of Part III.
Part IV Contents
Part IV, Reference Information, consists of Sections 16 and 17. Table iv summarizes
the contents of Part IV.
11 Configuring Expand-
Over-SNA Lines
Explains how to configure and start single-line
Expand-over-SNA line-handler processes.
12 Configuring Expand-
Over-ServerNet Lines
Explains how to configure Expand-over-ServerNet
line-handler processes.
13 Configuring Multi-Line
Paths
Explains how to configure and start multi-line
paths.
Table iii. Summary of Contents—Part III
Section Title Contents
14 Subsystem Control
Facility (SCF)
Commands
Describes the Subsystem Control Facility (SCF)
interface to the Expand subsystem and provides
SCF command syntax.
15 Tracing
Describes the tracing process when the SCF
TRACE command is used with commands
available in the PTrace facility.
Table iv. Summary of Contents—Part IV
Section Title Contents
16 Expand Modifiers
Describes the modifiers that are related to the
configuration of Expand line-handler processes.
Modifiers are listed in alphabetical order.
17 Subsystem Description
Provides a high-level technical description of the
architecture and dynamics of the Expand
subsystem.
Table ii. Summary of Contents—Part II
Section Title Contents (continued)