Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Modifiers
Expand Configuration and Management Manual — 529522-013
16 - 2
Required Modifiers
ASSOCIATESUBDEV Must be used to specify
•
The name of the X25AM subdevice to which an Expand-
over-X.25 line-handler process will bind.
•
The subdevice name of the SNAX/APN logical unit (LU)
used by an Expand-over-SNA line-handler process.
•
The name of the Asynchronous Transfer Mode (ATM)
service access point (SAP) used by an Expand-over-ATM
line-handler process.
Required by: Exp
and-over-X25 and Expand-over-SNA, and
Expand-over-ATM line-handler processes only.
Default: There
is no default value for Expand-over-NAM line-
handler processes; the default value is #IP for Expand-over-ATM
line-handler processes (the only value allowed for Expand-over-
ATM).
ATMSEL Specifies a hexadecimal selector byte for the ATM line used by
the
local Expand-over-ATM line-handler process.
Required by: Exp
and-over-ATM line-handler processes that use
switched virtual circuit (SVC) connections.
Default: %H80
CALLTYPE_ATMSAP Specifies that an ATM protocol direct service access point
(A
TMSAP) connection will be used.
Required by: Exp
and-over-ATM line-handler processes that run
through the SLSA subsystem.
Default: PV
C (CALLTYPE_PVC modifier) is the default
connection type.
CALLTYPE_PVC Specifies that a permanent virtual circuit (PVC)
connection will
be used.
Required by: Exp
and-over-ATM line-handler processes.
Default: PVC is the
default connection type.
CALLTYPE_SVC Specifies that a switched virtual
circuit (SVC) connection will be
used.
Required by: Exp
and-over-ATM line-handler processes.
Default: PV
C (CALLTYPE_PVC modifier) is the default
connection type.
DESTATMADDR Specifies the Asynchronous Transfer Mode (ATM) address
config
ured for the ATM line used by the Expand-over-ATM line-
handler process at the remote system.
Required by:
Expand-over-ATM line-handler processes that use
switched virtual circuit (SVC) connections.
Default: 20-byte null address.
Table 16-1. Required Modifiers (page 2 of 3)
Modifier Description