Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Modifiers
Expand Configuration and Management Manual — 529522-013
16 - 6
CLBIDLETIMER
CLBIDLETIMER
Default: 10
Units: Seconds
Range: 0.001 through 5:27.0
This modifier is applicable only to SWAN SA
T line, which applies to the connection
from the NonStop operating system to the SWAN adapter. Default value is the best
value. When the data connection from the operating system to the SWAN adapter is
idle, the Timer determines how often the linehandler process on the operating system
will send a status probe to the SWAN adapter.
CLOCKMODE_DCE/CLOCKMODE_DTE
Default: CLOCKMODE_DCE
Units: Not applicable
Range: Not applicable
These modifiers are applicable to direct-connect and satellite-connect Expand line-
handler processes only. The CLOCKMODE_DCE modifier disables the
communications line interface processor (CLIP) clock on the ServerNet wide area
network (SWAN) concentrator used by the line. It causes the SWAN concentrator to
provide no clocking. The CLOCKMODE_DTE modifier enables the communications
line processor (CLIP) clock. This modifier enables the internally generated clock when
it is used with the CLOCK modifier.
CLOCKSPEED_600/CLOCKSPEED_1200
CLOCKSPEED_2400/CLOCKSPEED_4800
CLOCKSPEED_9600/CLOCKSPEED_19200
CLOCKSPEED_38400/CLOCKSPEED_56000
CLOCKSPEED_115200
Default: CLOCKSPEED_19200
Units: Kilobits per second (Kbps)
Range: Not applicable
These modifiers are applicable to direct-connect and satellite-connect Expand line-
handler processes only. These modifiers override the default speed of the internally
generated communications line interface processor (CLIP) on the ServerNet wide area
network (SWAN) concentrator. The CLOCKMODE_DTE modifier must also be
specified to enable the internal clock.