Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Modifiers
Expand Configuration and Management Manual — 529522-013
16 - 8
DELAY n
For Expand-over-IP and Expand-over-ATM line-handler processes, the
CONNECTTYPE_PASSIVE modifier indicates that the Expand-over-IP or Expand-
over-ATM line-handler process will wait for incoming call requests; it will not initiate
connect requests.
If specified with AFTERMAXRETRIES_PASSIVE, the CONNECTTYPE_PASSIVE
modifier will revert to active connect mode. To get the line up in passive connect mode,
add the AFTERMAXRETRIES_DOWN modifier.
DELAY n
Default: 10 (0.10 second)
Units: Milliseconds
Range: 0 through 511 (0 to 5.11 seconds)
This Layer 2 modifier is applicable to direct-connect Expand line-handler processes
only. This modifier sets the amount of time, in one-hundredth of a second increments,
that a data bit spends on the line during message transmission. The Expand line-
handler process uses the transmission size, the amount of delay before the message
can be dispatched, and the DELAY modifier value to select the most efficient line for
data transmission within a path that consists of multiple lines.
Transmission delay is usually minimal on a terrestrial link. Transmission delay on a
satellite link is greater than on a terrestrial link.
DESTATMADDR n
Default: (ISONSAP:%H0000000000000000000000000000000000000000)
Units: Not applicable
Range: Any valid ISO NSAP ATM address
This modifier is applicable to Expand-over-ATM line-handler processes that use
switched virtual circuits (SVCs). This modifier specifies the Asynchronous Transfer
Mode (ATM) address configured for the ATM line used by the Expand-over-ATM line-
handler process at the destination system.
The address must be specified by number in the form (ISONSAP:%Hatm-address)
where atm-address is the 20-byte ATM address.