Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Modifiers
Expand Configuration and Management Manual — 529522-013
16 - 9
DESTIPADDR n
DESTIPADDR n
Default: 0.0.0.1
Units: Not applicable
Range: Any 36-character string
This modifier is applicable to Exp
and-over-IP line-handler processes only. This modifier
specifies the Internet Protocol (IP) address used by the remote (destination) Expand-
over-IP line-handler process. It is the IP address specified in the remote line-handler
process’ SRCIPADDR modifier.
The address must be specified by number (for example, 130.252.12.3). It is not
validated and need not be accessible. Configuring IP addresses is explained in the
TCP/IP Configuration and Management Manual.
DESTIPPORT n
Default: 1024
Units: Not applicable
Range: 0 through 65534
This modifier is applicable to Expand-over-IP line-handler processes only. This modifier
specifies the port number used by the remote (destination) Expand-over-IP line-
handler process. It is the port number specified in the remote line-handler process’
SRCIPPORT modifier. Port numbers are explained in the TCP/IP Configuration and
Management Manual.
DOWNIFBADQUALITY ON/ DOWNIFBADQUALITY OFF
Default: OFF
Units: Not applicable
Range: Not applicable
If set ON and the QUALITYTIMER timer expires, an EMS message is generated and
the line is aborted (see the
QUALITYTIMER n and QUALITYTHRESHOLD n
parameters). If set OFF and the QUALITYTIMER timer expires, an EMS message is
generated and the line is not aborted.
This modifier is applicable to both single-line and multi-line IP, ATM, satellite, and
SWAN line-handler processes.
EXTMEMSIZE n
Default: 8192 Kbytes (4 megabytes)
Units: Kbytes
Range: 0 through 32767 Kbytes (32 megabytes)
This modifier allows you to specify the base size of extended memory for Exp
and’s
internal buffer pool.