Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Modifiers
Expand Configuration and Management Manual — 529522-013
16 - 17
LINEPRIORITY n
LINEPRIORITY n
Default: 1
Units: Integers
Range: 1 through 9
This modifier is applicable to all multi-line types. It can be set in the ran
ge 1 to 9. The
default is 1. The higher the number, the lower priority to use that line. If lines have
equal priority, the relative line speeds and transmission delays are used to select the
next line.
LINETF n
Default: 0 (unset)
Units: Not applicable
Range: 0 through 186
The LINETF modifier has a range of 0 to 186 to designate the line time factor in
selecting the best path to other nodes in the network. A smaller number indicates a
more desirable path for routing. If you set the LineTF, it overrides the RSIZE, SPEED,
or SPEEDK parameters in calculating the time factor for the line (PathTF overrides all
parameters, including LINETF).
If LINETF is left unset (a zero value), this parameter is not used in setting the time
factor. Either RSIZE, SPEED, SPEEDK, LINETF, or PATHTF must be set, else the line
handler will display a configuration error. For more information on establishing time
factors, see Setting Time Factors on page 17-23.
MAXRECONNECTS n
Default: 0
Units: Not applicable
Range: 0 through 32767
This modifier is applicable to Exp
and-over-NAM, Expand-over-IP, Expand-over-ATM,
and Expand-over-ServerNet line-handler processes.
For Expand-over-NAM and Expand-over-ServerNet line-handler processes, this
modifier specifies the maximum number of times the Exp
and line-handler process will
try a connect request after successfully binding to the network access method (NAM)
interface.
For Expand-over-IP and Expand-over-ATM line-hand
ler processes, this modifier
specifies the maximum number of times the Expand-over-IP or Expand-over-ATM line-
handler process will try to connect to the remote Expand-over-IP or Expand-over-ATM
line-handler process. A value of 0 indicates an infinite number of retries.