Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Modifiers

Expand Configuration and Management Manual — 529522-013

16 - 27

TIMERRECONNECT n

This specifies time interval that the Expand-over-NAM or Expand-over-ServerNet line-

handler process will wait to send out a probe to obtain the status of the NAM process,

or the time interval that the Expand-over-IP or Expand-over-ATM line-handler process

will wait to probe the remote Expand-over-IP or Expand-over-ATM line-handler

process. The time interval is specified in the format described in Time Values on

page 14-6; the time values section applies only to AL

TER PATH or ALTER LINE

commands. For the ADD DEVICE command, the format of the time is just plain

seconds.

Probes will continue to be sent out the number of times specified by the

RETR

YPROBE attribute. If the TIMERPROBE/RETRYPROBE cycle expires without a

returned status, the Expand-over-NAM, Expand-over-ServerNet, Expand-over-ATM, or

Expand-over-IP line-handler process declares the network unavailable.

See also RETRYPROBE n and TIMERRECONNECT n.

TIMERRECONNECT n

Default: 30 for Expand-over-IP, Expand-over-ATM, and Expand-over-NAM

5 for Expand-over-ServerNet

Units: seconds

Range: 30 through 32767 for Expand-over-IP, Expand-over-ATM

0 through 32767 for Expand-over-NAM and Expand-over-ServerNet

This specifies the time interval that the Expand-over-NAM, Expand-over-ATM, Expand-

over-IP, or Expand-over-ServerNet line-handler process will wait for a connection

request to succeed. The range does not include 0. The time interval is specified in the

format described in Time Values on page 14-6; the time values section applies only to

ALTER PATH or ALTER LINE commands. For the ADD DEVICE command, the format

of the time is just plain seconds.

Expand line-handler processes on opposite ends of an X25AM line should use different

values for TIMERRECONNECT.