Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Modifiers
Expand Configuration and Management Manual — 529522-013
16 - 29
V6SRCIPADDR n
V6SRCIPADDR n
Default: 0000:0000:0000:0000:0000:0000:0000:0000
Units: Not applicable
Range: Any 45-character string
This modifier is applicable to Exp
and-over-IP line-handler processes only. This modifier
specifies the source Internet Protocol (IP) address associated with the NonStop
TCP/IPv6 process used by the local Expand-over-IP line-handler process. Because a
NonStop TCP/IPv6 process can have more than one IP address, you must specify to
the Expand-over-IP line-handler process which IP address to use.
The default must be changed before the line is st
arted. The address must be specified
by number (for example, 31CA:B145:5489:1034:1784:B245:4029:1257). Configuring
NonStop TCP/IPv6 addresses is explained in the TCP/IPv6 Configuration and
Management Manual.
Profiles
This subsection lists the modifiers that are contained in each of the profiles.
Single-Line Expand Line-Handler Process Modifiers
Table 16-3 lists the modifiers in the profiles provided for single-line Expand line-handler
processes.
Table 16-3. Single-Line Path Modifiers (page 1 of 4)
Modifier
PEXQSSWN PEXQSSAT PEXQSIP PEXQATM PEXQSNAM PEXPSSN PEXQSFX
AFTERMAXRETRIES_
DOWN
X X X X X
AFTERMAXRETRIES_
PASSIVE
X X X X X
ASSOCIATEDEV
X X X X X
ASSOCIATESUBDEV
X X
ATMSEL
X
CALLTYPE_ATMSAP
X
CALLTYPE_PVC
X
CALLTYPE_SVC
X
CLOCKMODE_DCE
X X
CLOCKMODE_DTE
X X
CLOCKSPEED_600
X X
CLOCKSPEED_1200
X X
CLOCKSPEED_2400
X X