Expand Configuration and Management Manual (H06.21+, J06.10+)

Expand Configuration and Management Manual — 529522-013
1 - 1
1 Configuration Quick Start
This section provides the basic information to define and start an Expand line-handler
process. This procedure requires that you use the default values provided by the
Expand subsystem for most configuration modifiers. If you want a customized
configuration, or if you want to change your configuration, see Part II, Configuring the
Expand Subsystem.
Task Summary
Configuring and starting an Expand line-handler process involves these tasks:
•
Task 1: Configure and Start $NCP on page 1-2
•
Task 2: Start the Expand Manager Process on page 1-3
•
Task 3: Add the Expand Line-Handler Profile(s) on page 1-4
•
Task 4: Add the Expand Line-Handler Process on page 1-6
•
Task 5: Start the Expand Line-Handler Process on page 1-18
Assumptions
At the beginning of this procedure, the Integrity NonStop NS-series server is assumed
to be in this state:
•
The default software configuration provided by HP manufacturing is running.
•
The initial OSM configuration is complete.
•
The ServerNet LAN Systems Access (SLSA) subsystem has been configured and
started, and a LAN adapter has been installed and started.
•
A NonStop TCP/IP process and Ethernet SUBNET have been created and started.
•
The WAN manager process ($ZZWAN) has been created and started.
•
The WAN subsystem Concentrator Manager (ConMgr), WANBoot, TFTP server,
and the SNMP trap multiplexer processes have been created and started.
•
The ServerNet wide area network (SWAN) concentrator has been installed,
configured, and started and has an available WAN line.
Note. The Integrity NonStop NS1000 server does not support ServerNet clusters.