Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Quick Start

Expand Configuration and Management Manual — 529522-013

1 - 2

Task 1: Configure and Start $NCP

The network control process ($NCP) is responsible for initiating and terminating server-

to-server connections and maintaining network-related system tables, including routing

information. $NCP must be running at every node in the Expand network before

Expand lines can be started.

To configure and start the network control process, perform these steps:

1. Log on to the Integrity NonStop NS-series server using the super ID

(SUPER.SUPER) and enter the correct password at the Password: prompt.

> LOGON SUPER.SUPER

Password:

2. At the TACL prompt, start the Subsystem Control Facility (SCF).

> SCF

3. Create a profile for the network control process.

-> ADD PROFILE $ZZWAN.#PEXPNCP, FILE $SYSTEM.SYS00.PEXPNCP

4. Create the network control process.

-> ADD DEVICE $ZZWAN.#NCP, IOPOBJECT $SYSTEM.SYS00.NCPOBJ, &

PROFILE PEXPNCP, CPU 2, ALTCPU 3, TYPE (62,6), RSIZE 1

5. Start the network control process

-> START DEVICE $ZZWAN.#NCP

Where to Find More Information About This Task

Section 6, Configuring the Network Control Process

Note. Do not log off or exit from SCF after completing this task. The remaining tasks in this

procedure require the use of SCF commands and super ID privileges.