Expand Configuration and Management Manual (H06.21+, J06.10+)

Troubleshooting
Expand Configuration and Management Manual — 529522-013
20 - 7
SCF Commands
The SCF INFO PROCESS $NCP LINESET command is useful for displaying the
status of a selected path and the lines in that path. The SCF INFO PROCESS $NCP,
LINESET command also displays the current file-system error. Example 20-4 shows an
example of an SCF INFO PROCESS $NCP, LINESET display.
Table 20-4 lists and describes the file-system error numbers that are most commonly
reported by the SCF INFO PROCESS $NCP, LINESET command.
Example 20-4. SCF INFO PROCESS $NCP, LINESET Display
-> INFO PROCESS $NCP, LINESET
EXPAND Info PROCESS $NCP , LINESET
LINESETS AT \NODEA (117) #LINESETS=7 TIME: FEB 24,2003 13:55:04
LINESET NEIGHBOR LDEV TF PID LINE LDEV STATUS FileErr#
1 S \NODEB (082) 122 1 ( 1, 334)
1 122 READY
2 S \NODEB (082) 123 1 ( 0, 333)
1 123 READY
3 S \NODEB (082) 121 1 ( 0, 332)
1 121 READY
4 \NODEB (082) 131 -- -- -----
1 131 NOT READY (066)
5 \NODEB (082) 125 3 ( 2, 271)
1 125 READY
6 \NODEF (247) 132 -- -- -----
1 132 NOT READY (066)
7 \NODEF (247) 175 -- -- -----
1 212 NOT READY (066)
2 254 NOT READY (066)
3 256 NOT READY (066)
4 259 NOT READY (066)
Table 20-4. Common File-System Errors (page 1 of 2)
Error Cause Recovery
66 This error indicates that the line
was aborte
d or was never
started.
If the communications line interface processor
(CLIP) remains STOPPED, use these SCF
commands:
ABORT LINE $device_
name
START LINE $device_name
124 This error can occur when you
att
empt to start a line. The
causes of this error differ
depending on the type of line.
If error 124 persists, there can
be
a hardware problem.
The recovery depends on the cause of the
erro
r. If the error does not persist, no action is
necessary. However, if the error does persist, a
hardware error can be indicated and you
should contact your HP representative.
Note. For more information on network-related file-system errors, see the Operator Messages Manual.