Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Quick Start
Expand Configuration and Management Manual — 529522-013
1 - 7
Creating a Single-Line Expand Line-Handler
Process
2. Using the information obtained from the SCF STATUS ADAPTER command,
record the following information in the SCF ADD DEVICE COMMAND
WORKSHEET (see Table 1-3 on page 1-10):
a. The name of the SWAN concentrator with the available WAN line in the
concname field. (For example: S01.)
b. The CLIP (1, 2, or 3) containing the available WAN line in the clipnum field.
(For example: 1.)
c. The line number of the available W
AN line in the linenum field. (For example,
1.)
d. Record the configured path that you prefer to use (A or B) in the pathname
field. (For example: A.) Configured paths are indicated by the word
CONFIGURED following the path name in the SCF STATUS ADAPTER
command display.
Example 1-1. SCF STATUS ADAPTER Command
WAN Manager STATUS ADAPTER for ADAPTER \NODEA.$ZZWAN.#S01
State........... STARTED
Number of clips. 3
Clip 1 status : CONFIGURED
Clip 2 status : CONFIGURED
Clip 3 status : CONFIGURED
WAN Manager STATUS SERVER for CLIP \NODEA.$ZZWAN.#S01.1
State :......... STARTED
Path A..........: CONFIGURED
Path B..........: CONFIGURED
Number of lines. 2
Line............ 0 : $X25A
Line............ 1 : FREE
WAN Manager STATUS PATH for PATH \NODEA.$ZZWAN.#S01.1.A
State :......... STARTED
MEDIA TYPE...... ETHERNET
MEDIA ADDRESS... %H000000000000