Expand Configuration and Management Manual (H06.21+, J06.10+)

Troubleshooting
Expand Configuration and Management Manual — 529522-013
20 - 27
Expand-Over-ATM Problems
Resolving Expand-Over-ATM Wait Problems
If the SCF STATUS LINE command with the DETAIL option displays WAIT in the
Detailed State field, check the Detailed Info field for more detailed error information.
Table 20-15 describes the messages that might be displayed in the Detailed Info field.
Detailed Info Field for Expand-Over-ATM Lines
The Detailed Info field displays the last error message returned to the Expand-over-
ATM line-handler process. This field provides more information about the current
detailed state. Each message returned to this field corresponds to an Event
Management Service (EMS) event number generated by the Expand subsystem.
Table 14-7 on page 14-109 describes the messages that can be returned to the
Detailed Info field.
For cause, effect, and recovery information for the event numbers generated by the
Expand subsystem, see the Operator Messages Manual.
Table 20-15. Messages Displayed in the Detailed Info Field (Expand-Over-ATM)
Message Description
Shared memory system unavailable The QIO subsystem is not available. Check the
st
ate of the QIO subsystem. The line will become
ready when the QIO subsystem becomes available.
ATM subsystem unavailable, error
nn
n
The ATM line associated with the Expand-over-
ATM line-handler process is not available. Check
the state of the ATM line. The Expand-over-ATM
line will become ready when the associated ATM
line becomes available. ATM error codes (nnn) are
described in the ATM Configuration and
Management Manual.
PVC unavailable, error nn
n The ATM permanent virtual circuit (PVC) used by
the Expand-over-ATM line-handler process is not
available. Make sure the PVC is configured
properly. The Expand-over-ATM line will become
ready when the associated ATM line becomes
available. ATM error codes (nnn) are described in
the ATM Configuration and Management Manual.
SVC unavailable, error nn
n The ATM switched virtual circuit (SVC) used by the
Expand-over-ATM line-handler process is not
available. Make sure the SVC is configured
properly and that network connectivity is functional.
The Expand-over-ATM line will become ready when
the associated ATM line becomes available. ATM
error codes (nnn) are described in the ATM
Configuration and Management Manual.