Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Quick Start
Expand Configuration and Management Manual — 529522-013
1 - 10
Creating a Single-Line Expand Line-Handler
Process
Expand-Over-IP Line-Handler Process
The Expand-over-IP line-handler process must be associated with a NonStop TCP/IP
process for conventional NonStop TCP/IP, a CIPSAM process for Cluster I/O Protocols
(CIP), or a TCP6SAM process for NonStop TCP/IPv6. Expand uses an Ethernet
SUBNET and a User Datagram Program (UDP) port defined for the NonStop TCP/IP
process.
The procedure to configure NonS
top TCP/IP processes is not described here. For
more information, see Section 8, Configuring Expand-Over-IP Lines.
To create an Expand-over-IP line-handler process, perform this step:
1. Add the Expand-over-IP line-handler process as a device to the W
AN subsystem.
-> ADD DEVICE $ZZWAN.#device_name, PROFILE name,&
IOPOBJECT $SYSTEM.SYS00.LHOBJ, CPU cpunum, ALTCPU altcpu,&
TYPE (63,0), RSIZE 0, PATHTF 3, NEXTSYS sysnum, &
ASSOCIATEDEV tcpip_process, DESTIPADDR dipaddr,&
DESTIPPORT dipport, SRCIPADDR sipaddr, &
SRCIPPORT sipport
Table 1-3. SCF ADD DEVICE Command Worksheet
Parameter Value/Description
device_name The name you want to assign to the Expand line-handler process.
name The name of the profile you created in
Task 3: Add the Expand Line-
Handler Profile(s) on page 1-4.
concname ____________________ (Task 4, Step 2a)
clipnum ____________________ (Task 4, Step 2b)
linenum ____________________ (Task 4, Step 2c)
pathname ____________________ (Task 4, Step 2d)
cpunum ____________________ (Task 4, Step 5)
altcpunum ____________________ (Task 4, Step 5)
sysnum Specifies the number of the system connected to the other end of the
line. System numbers can
be displayed using the SCF INFO
PROCESS $NCP, LINESET command.
Note. The device name is a string of alphanumeric characters. The strin
g is limited to the
pound (#) sign followed by seven characters. The first character must be an alphanumeric
character. For subsystem-specific naming guidelines, see the WAN Subsystem Configuration
and Management Manual.
Note. To use CIP for IP communications, add the Exp
and-over-IP line-handler device in
the same way as done in
Select a CIPSAM Process for your NonStop TCP/IP process.
The CIP also supports IPv6 communications.