Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Quick Start
Expand Configuration and Management Manual — 529522-013
1 - 12
Creating a Single-Line Expand Line-Handler
Process
Expand-Over-ATM Line-Handler Process
The Expand-over-ATM line-handler process must be associated with an Asynchronous
Transfer Mode (ATM) line. It can use a switched virtual circuit (SVC) or a permanent
virtual circuit (PVC) connection.
Expand-over-ATM lines can also use the A
TMSAP connection option through the
SLSA subsystem.
Configuring the ATM subsystem is not described here; you can find information about
this topic in Section
9, Configuring Expand-Over-ATM Lines.
To create an Expand-over-ATM line-handler process, perform this step:
cipsam_process* The name of the CIP transport-service provider process you want to
associate with the Expand-over-IP line-handler process. The
CIPSAM process does not need to be configured in the same
processor pair as the Expand-over-IP line-handler process. In CIP,
the monitor process ($ZZCIP.#ZCMn, where n is the processor
number) is configured in all processors by default. Therefore,
additional considerations are not required for ensuring its operation
in the Expand-over-IP line-handler process pair. If you use CIP for
INET (IPv4) operations, the additional parameters for IPv6,
IPVER_IPV6, V6SRCIPADDR, and V6DESTIPADDR are not
needed. However, the DESTIPADDR parameter is required for INET
operations. CIP has the ability to restrict data communications to a
particular CLIM and this might affect Expand configuration. For
more information on this feature, see
Internet Protocol (IP)
Networks on page 3-4.
dipaddr The IP address used by the remote (destination) Expand-over-IP
line
-handler process. The address must be specified by number.
dipport The UDP port number used by the remote (destination) Expand-
o
ver-IP line-handler process.
sipaddr The IP address used by the NonStop
TCP/IP process specified by
tcpip_process. The address must be specified by number.
sipport The UDP port number used by this Expand-over-IP line-handler
p
rocess. Valid values are in the range 0 through 65536. Do not use
well-known ports in the range 0 through 1023.
ipv6srcaddress The IP address used by the NonStop
TCP/IP process specified by
the tcpipV6_process. The address must be specified by
number.
ipv6destaddress
The IP address used by the NonStop TCP/IP process specified by
the tcpipV6_process. The address must be specified by
number.
Table 1-4. SCF ADD DEVICE Syntax: Expand-Over-IP (page 2 of 2)
Parameter Description
* Supported only on systems running J06.04 and later J-series RVUs.