Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Quick Start
Expand Configuration and Management Manual — 529522-013
1 - 14
Creating a Single-Line Expand Line-Handler
Process
Expand-Over-X.25, Expand-Over-SNA and Expand-Over-
ServerNet Line-Handler Processes
Expand-over-X.25, Expand-over-SNA, and Expand-over-ServerNet line-handler
processes require the services of these software components:
•
The Expand-over-X.25 line-handler process must be associated with an X25AM
process. It uses a NAM subdevice defined for the X25AM process. You can find
information about this topic in Section 10, Configuring Expand-Over-X.25 Lines.
•
The Expand-over-SNA line-handler process must be associated with a SNAX/APN
line-handler process. It uses a particular SNAX/APN line and logical unit (LU)
defined for the SNAX/APN line-handler process. You can find more information
about this topic in Section
11, Configuring Expand-Over-SNA Lines.
•
The Expand-over-ServerNet line-handler process must be associated with the
ServerNet monitor process ($ZZSCL), a component of the ServerNet cluster
subsystem. You can find more information about this topic in Section 12,
Configuring Expand-Over-ServerNet Lines.
To create an Expand-over-X.25, Expand-over-SNA, or Expand-over-ServerNet line-
handler process, perform this step:
1. Add the Expand-over-SNA, Expand-over-X.25, or Expand-over-ServerNet line-
handler process as a device to the WAN subsystem.
-> ADD DEVICE $ZZWAN.#device_name, PROFILE name,&
IOPOBJECT $SYSTEM.SYS00.LHOBJ, CPU cpunum, ALTCPU altcpu,&
pvc_name The name of the permanent virtual circuit (PVC) used by the Expand-
over-ATM line-handler process. This modifier is only applicable to
Expand-over-ATM line-handler processes that use PVC connections.
selector-byte A selector byte for the ATM line used by this Expand-over-ATM line-
han
dler process. The selector byte is the last (rightmost) byte of the
ATM address. This modifier is only applicable to Expand-over-ATM
line-handler processes that use SVC connections.
atm-address The 20-byte ATM address configured for the ATM line used by the
Exp
and-over-ATM line-handler process at the remote system. The
address must be preceded by the characters ISONSAP:%H and must
be enclosed in parentheses. This modifier is only applicable to
Expand-over-ATM line-handler processes that use SVC connections.
sysnum
The number of the system connected to the other end of the line.
System numbers can be displayed using the SCF INFO PROCESS
$NCP, LINESET command.
Table 1-5. SCF ADD DEVICE Syntax: Expand-Over-ATM (page 2 of 2)
Parameter Description