Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Quick Start
Expand Configuration and Management Manual — 529522-013
1 - 15
Creating a Multi-Line Path
TYPE (63,subtype), RSIZE 0, PATHTF 3, ASSOCIATEDEV process, &
ASSOCIATESUBDEV #subdevice, NEXTSYS sysnum
Creating a Multi-Line Path
This section describes how to configure a multi-line path.
Note. If you want the Expand-over-X.25 or Expand-over-SNA line-handler process to be part
of a multi-CPU path, specify the SUPERPATH_ON modifier in the SCF ADD DEVICE
command. You can configure a maximum of 16 paths in a multi-CPU path. Expand-over-
ServerNet line-handler processes cannot participate as a member of a multi-CPU path
(superpath).
Table 1-6. SCF ADD DEVICE Syntax: Expand-Over-X.25, Expand-Over-SNA, and
Expand-Over-ServerNet
Parameter Description
device_name The name you want to assign to the Expand line-handler process.
name The name of the profile you created in
Task 3: Add the Expand Line-
Handler Profile(s).
cpunum The primary processor number.
altcpu The alternate processor number.
subtype The subtype. The subtype is 0 for Exp
and-over-X.25 and Expand-over-
SNA line-handler processes; it is 4 for Expand-over-ServerNet line-
handler processes.
process
•
For Expand-over-X.25: the name of an X25AM line-handler
process.
•
For Expand-over-SNA: the name of a SNAX/APN line-handler
process.
•
For Expand-over-ServerNet: must be $ZZSCL.
subdevice
•
For Expand-over-X.25: the name of an X25AM subdevice defined
for the X25AM process specified by process.
•
For Expand-over-SNA: the name of a local LU (with the NAM
protocol) defined for the SNAX/APN process specified by
process.
•
For Expand-over-ServerNet: this modifier is not used.
sysnum The number of the system connected to the other end of the line.
System numbers can be displayed
using the SCF INFO PROCESS
$NCP, LINESET command.