Expand Configuration and Management Manual (H06.21+, J06.10+)

Configuration Quick Start

Expand Configuration and Management Manual — 529522-013

1 - 16

Creating a Multi-Line Path

1. Create the path-logical device.

-> ADD DEVICE $ZZWAN.#path_name, PROFILE name,&

IOPOBJECT $SYSTEM.SYS00.LHOBJ, CPU cpunum, ALTCPU altcpu,&

TYPE (63,1), RSIZE 0, PATHTF 3, NEXTSYS sysnum

Note. If you want the multi-line path to be part of a multi-CPU path, specify the

SUPERPATH_ON modifier in the SCF ADD DEVICE command. You can configure a maximum

of 16 paths in a multi-CPU path.

Table 1-7. ADD DEVICE Syntax: Path-Logical Device

Parameter Description

path_name The name you want to assign to the path-logical device.

name The name of the profile you created in Task 2, Step 2a.

cpunum The number of the primary processor.

altcpu The number of the alternate processor.

sysnum The number of the system connected to the other end of the multi-line

ath. System numbers can be displayed using the SCF INFO

PROCESS $NCP, LINESET command.