Expand Configuration and Management Manual (H06.21+, J06.10+)

Contents
Expand Configuration and Management Manual — 529522-013
iv
8. Configuring Expand-Over-IP Lines
Required Hardware and Software 7-2
QIO Subsystem 7-3
Wide Area Network (WAN) Shared Driver 7-3
NonStop TCP/IP Process 7-3
Local Area Network (LAN) Driver and Interrupt Handlers (DIHs) 7-3
ServerNet Wide Area Network (SWAN) Concentrator 7-4
Topology Considerations 7-4
Summary of Configuration Steps 7-5
Step 1: Find an Available WAN Line 7-5
Step 2: Create a Profile for the Line-Handler Process 7-7
ADD Profile Command 7-7
Examples 7-8
Step 3: Create the Line-Handler Process 7-8
ADD DEVICE Command 7-8
Considerations 7-10
Examples 7-10
Step 4: Start the Line-Handler Process 7-11
Step 5: Start the Line 7-11
Profile Modifiers 7-12
Modifiers for Special Features 7-12
PEXQSSWN and PEXQSSAT Modifiers 7-12
8. Configuring Expand-Over-IP Lines
Required Hardware and Software 8-2
QIO Subsystem 8-3
NonStop TCP/IP Process 8-4
NonStop TCP/IPv6 Process 8-4
CIP Process 8-4
Redundancy in Ethernet Adapters 8-4
Local Area Network (LAN) Driver and Interrupt Handlers (DIHs) 8-5
Asynchronous Transfer Mode (ATM) Subsystem 8-6
LAN or ATM Adapters or the CLIM 8-6
Topology Considerations 8-7
Summary of Configuration Steps 8-8
Step 1 (A): Select a Process and SUBNET for NonStop TCP/IP Use 8-9
Select a NonStop TCP/IP Process 8-9
Select a SUBNET for NonStop TCP/IP 8-10
Creating an Ethernet SUBNET or ATM SUBNET 8-10
Step 1 (B): Select a Process and SUBNET for NonStop TCP/IPv6 Use 8-11