Expand Configuration and Management Manual (H06.21+, J06.10+)

Contents

Expand Configuration and Management Manual — 529522-013

9. Configuring Expand-Over-ATM Lines

Select a SUBNET for NonStop TCP/IPv6 Use 8-11

Select a TCP6SAM Process 8-13

Creating an Ethernet Subnet 8-14

Step 1 (C): Select a Process and SUBNET for CIP Use 8-15

Select a CIPSAM Process 8-15

Obtain an IP Address to associate with your Expand Line- Handler Process 8-15

Step 2 (A): Identify an Available UDP Port Number 8-17

Step 2 (B): Identify an Available UDP Port Number for NonStop TCP/IPv6 Use 8-18

Step 2 (C): Identify an available UDP Port Number for CIP Use 8-20

Step 3: Create a Profile for the Line-Handler Process 8-22

ADD Profile Command 8-22

Example 8-23

Step 4: Create the Line-Handler Process 8-23

ADD DEVICE Command 8-23

Considerations 8-26

Example 8-27

Step 5: Start the Line-Handler Process 8-27

Step 6: Start the Line 8-28

Add a Configured Tunnel for an Expand Line 8-28

Add a Configured Tunnel for an Expand Line for CIP 8-30

Profile Modifiers 8-32

Recommended Modifiers 8-32

Modifiers for Special Features 8-33

PEXQSIP Modifiers 8-33

9. Configuring Expand-Over-ATM Lines

Required Hardware and Software 9-2

QIO Subsystem 9-2

ATM Subsystem 9-3

SLSA Subsystem 9-3

ATM 3 ServerNet Adapter (ATM3SA) 9-3

Topology Considerations 9-4

Summary of Configuration Steps 9-5

Step 1: Identify the ATM Connection 9-5

Configuring an Expand Line-Handler Process That Uses a PVC 9-6

Configuring an Expand Line-Handler Process That Uses an SVC 9-6

Configuring an Expand Line-Handler Process That Uses ATMSAP 9-9

Step 2: Create a Profile for the Line-Handler Process 9-11

ADD Profile Command 9-11