NonStop NS2400 Series Planning Guide

Seismic Rack Physical Specifications

ValueSpecification

36UU Height

26.7 in (67.8 cm)Width

39.4 in (100.0 cm)Depth

TopCable Entry

1200 lbs (544.3 kg)Max Load

500 lbs (226.8 kg)Rack Weight (seismic rack)

485 lbs (220 kg)Rack Weight (seismic rack R2)

200 lbs (90.7 kg)Packaging and Pallet Weight (seismic rack)

150 lbs (29.6 kg)Packaging and Pallet Weight (seismic rack R2)

Including side panels.

Floor Space Requirements

RecommendedMinimum

Measurement cmincmin

13051.291.436Front (appearance side) clearance

13051.291.436Rear (service side) clearance

< 2.5< 1.0----Space between cabinets

68.627----Cabinet pitch

Unpacking area: When moving the cabinet off the shipping pallet, you need approximately 9 feet

(2.74 meters) on one side of the cabinet to allow you to slide the pallet out from under the cabinet

after the cabinet has been raised on the casters.

Seismic Rack Ground Connections

The NonStop NS2400ST seismic rack requires its own ground connections to the site ground.

There are two ground connections for the cabinet. These are designated with the ground symbol.

For detailed information about grounding the cabinet, ask your HP service provider to refer to the

NonStop NS2200 Series and NS2400 Series Hardware Installation Manual.

Intracabinet Grounding for Seismic Racks

Each NonStop NS2400ST seismic rack has two grounding rails at the rear of the cabinet in front

of the mounting rails. Ground cables are green with a yellow stripe and are used to connect an

enclosure to the cabinet grounding rail. Green hex-head ground screws and star washers secure

the green ground cables to the grounding rail. For detailed information about intracabinet grounding

and ground connections, ask your HP service provider to refer to the NonStop NS2200 Series

and NS2400 Series Hardware Installation Manual.

138 Specifications for NonStop NS2400ST Systems