NonStop NS2400 Series Planning Guide

IP ConfigurationTCP/IP StackGMS for IP CLIM Location in VIO
Enclosure
Hostname: osmlanx
IP: 192.168.36.11$ZTCP1100.3.4.1
Subnet:
%hFFFFFF00
Hostname: osmlany
Dedicated Service LAN Links With Telco CLIMs
You can implement up-system service LAN connectivity using Telco CLIMs, if the system has at least
two Telco CLIMs. The values in this table show the identification for the Telco CLIMs in a NonStop
NS2400 series system and connected to the maintenance switch. For example, in this table a Telco
CLIM named O100241 is connected to slot 4, port 1 of the VIO enclosure located in group 100,
module 2.
IP ConfigurationTCP/IP StackGMS for Telco CLIM Location in VIO
Enclosure
IP: 192.168.36.10$ZTCP0100.2.4.1
Subnet:
%hFFFFFF00
Hostname: osmlanx
IP: 192.168.36.11$ZTCP1100.3.4.1
Subnet:
%hFFFFFF00
Hostname: osmlany
Initial Configuration for a Dedicated Service LAN
New systems are shipped with an initial set of IP addresses configured. You can change these
preconfigured IP addresses to addresses appropriate for your LAN environment. For a listing of
these initial IP addresses, see “IP Addresses” (page 156).
Factory-default IP addresses for the Ethernet ports are available from your HP service provider (in
the Versatile I/O Manual.) IP addresses for SWAN concentrators are in the WAN Subsystem
Configuration and Management Manual.
You must change the preconfigured IP addresses on:
• The backup system console so it does not conflict with the primary system console.
• Any system console if you want to add a new NonStop system to an existing maintenance
LAN.
Keep track of all the IP addresses in your system so that no IP address is assigned twice.
The NonStop Maintenance LAN DHCP DNS Configuration Wizard, a component of OSM Console
Tools software that is installed on NonStop system consoles, can be used to configure DHCP and
DNS services required on your dedicated service LAN. Most of this configuration is done by your
HP service provider during initial configuration of the dedicated service LAN, when additional
NonStop systems are added, or when adding or replacing a NonStop system console. Ask your
HP service provider to refer to the NonStop Dedicated Service LAN Installation and Configuration
Guide.
Additional Configuration for OSM
If you require a faster connection to the OSM Service Connection, see "Configuring Additional
TCP/IP Processes for OSM Connectivity," in the OSM Configuration Guide.
Dedicated Service LAN 159