NonStop NS2400 Series Planning Guide

6 Hardware Configuration in NonStop NS2400 Cabinets
This section shows example configurations of hardware components within 36 and 42U modular
cabinets for a NonStop NS2400 commercial system.
NOTE: Hardware configuration drawings in this section represent the physical arrangement of
the modular enclosures but do not fully show PDUs. For information about PDUs, see “Power
Distribution for NonStop NS2400 Series Systems In Intelligent Racks” (page 52).
Maximum Number of Modular Components, NonStop NS2400 Series
System
This table shows the maximum number of the modular components installed in an NS2400 series
system. These values might not reflect the system you are planning and are provided only as an
example, not as exact values.
NonStop NS2400 Series SystemEnclosure or Component
1
4-processor2-processor
42Blade element (rx2800 i4)
11System console
22VIO enclosure
44Storage CLIM
22IP CLIM
22Telco CLIM
11CLIM patch panel
84SAS disk enclosure
22Maintenance switch
11HP R5000 UPS (for single-phase)
11HP R12000/3 UPS (for three-phase)
22Extended runtime module (ERM) (for
single-phase)
22ERM (for three-phase)
1
See “IP and Telco CLIM Coexistence Limits ” (page 99) for information about coexistence limits for IP and Telco CLIMs.
IP and Telco CLIM Coexistence Limits
Your NonStop NS2400 series system supports the following combinations of IP and Telco CLIMs:
CLIM Coexistence Limits
6 Supported Combinations
Telco CLIMIP CLIM
00
01
10
11
Maximum Number of Modular Components, NonStop NS2400 Series System 99