NonStop Servlets for JavaServer Pages (NSJSP) 6.1 System Administrator's Guide

Managing NSJSP
NonStop Servlets for JavaServer Pages (NSJSP) 6.1 System Administrator’s Guide—596210-006
4-41
Start the NSJSP Server Class
Using the NSJSP Manager application, you can start an NSJSP Server Class that is in
the STOPPED or THAWED state.
To start the NSJSP Server Class, complete the following steps:
1. Click the Server Class tab.
The System Information page appears.
2. Click the Server Class Operations.
3. Perform one of the following steps depending on the number of PATHMONs
configured:
a. If the server class is configured on only one PATHMON, click Start.
b. If the server class is configured in a TS/MP Pathway domain, complete the
following steps:
1. Select the Pathmon Name, which has the server class to be started.
2. Click Start.
The following message is displayed for Steps 3a and 3b:
Start Initiated. The operation may take a few minutes to
complete.
Figure 4-23 shows the Server Class Operations page after starting the server class
configured under the $YSB6 PATHMON.
WARNING. Wait for a minute or two for the operation to complete before performing any other
operation on the NSJSP Manager application interface. The time required for an operation to
complete depends on the number of requests serviced by the server class at the time of the
stop operation and the number of server class processes that are running.
Figure 4-23. Server Class with the $YSB6 PATHMON in the RUNNING State