NonStop Servlets for JavaServer Pages (NSJSP) 6.1 System Administrator's Guide

Configuring NSJSP
NonStop Servlets for JavaServer Pages (NSJSP) 6.1 System Administrator’s Guide—596210-006
3-5
Configuration Files for the Server Classes
Configuration Files for the Server Classes
An NSJSP installation, by default, creates two server classes, the Servlet server class and the
Admin server class. For definitions of the Servlet and the Admin Server Classes, see
Table 3-1.
The following files are used to configure these server classes and how they are used
by iTP Secure WebServer:

The Generic servlet.config File

The Installation-Specific servlet.config File

The nsjspadmin.config File

The filemaps.config File

The jdbc.config File
Note. You can use the default NSJSP configuration settings for development activities
without making any changes. However, when deploying NSJSP in a production
environment, the configuration might have to be modified to address the load, degree of
fault tolerance in the production environment and other considerations. For more
information on tuning NSJSP for performance, see the NonStop Servlets for JavaServer
Pages (NSJSP) Configuration White Paper at the following location:
http://www.docs.hp.com/en/588255-001/588255-001.pdf
.
Note. The syntax used in the generic servlet.config, installation-specific
servlet.config, nsjspadmin.config, filemaps.config, and jdbc.config
files is from the Tool Command Language (Tcl) and the configuration directives are defined
by iTP Secure WebServer. For more information about Tcl and the configuration directives,
see the iTP Secure WebServer System Administrator's Guide.