RDF System Management Manual for H-Series RVUs (RDF 1.8)

{RTDWARNING }
{RDFNET }
STOP RDF
The STOP RDF command shuts down the RDF subsystem.
Where Issued: Primary or backup system (can be issued on the backup system only when all
communications lines to the primary system are down).
Security: Super-user group member with remote password from the primary system to the
backup.
STOP RDF { [, DRAIN ] }
{ [, REVERSE ] }
STOP SYNCH
The STOP SYNCH command is used as part of the online database synchronization protocol.
See the descriptions of online database synchronization in Chapter 7 (page 155) for the proper
use of this command.
Where Issued: Primary system.
Security: Any user.
STOP SYNCH
STOP UPDATE
The STOP UPDATE command suspends updating of the backup database and stops all updater
processes.
Where Issued: Primary system only.
Security: Super-user group member with remote password from the primary system to the
backup.
STOP UPDATE [, TIMESTAMP timestamp ]
TAKEOVER
The TAKEOVER command causes the backup database to become the database of record.
Where Issued: Backup system only.
Security: Super-user group member.
TAKEOVER [!]
UNPINAUDIT
The UNPINAUDIT command unpins TMF audit-trail files on the primary system.
Where Issued: Primary system only.
Security: Super-user group member.
UNPINAUDIT
VALIDATE CONFIGURATION
The VALIDATE CONFIGURATION command validates the parameters in the RDF configuration
file.
Where Issued: Primary system only.
Security: Super-user group member.
VALIDATE CONFIGURATION
326 RDF Commands Quick Reference