RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The backup process takes over, but not in fault-tolerant mode, until the primary
process can be re-created.
Recovery Scan the EMS event log to determine why the process abended. An INSPECT
SAVEABEND file should have been created in the volume and subvolume where you placed
the RDF/IMP software; you should save that file for problem resolution by your service
provider.
717
Primary processor down
Cause The primary CPU of a NonStop process pair has stopped.
Effect The backup process takes over, but not in fault-tolerant mode. The primary process
will be re-created after its CPU is reloaded.
Recovery Reload the downed processor.
718
Switched to original primary processor
Cause The original backup process of a NonStop process pair has successfully created a
backup process in the configured primary processor and has successfully switched processing
to that process.
Effect The NonStop process pair is switching primary and backup roles so that the primary
process is now running in the CPU configured as the primary processor.
Recovery This is an informational message; no recovery is required.
719
Bad parameter in CHECKPOINT - status nnn
nnn
is the status word returned by CHECKPOINT.
Cause A CHECKPOINT call from the primary process of a NonStop process pair to its
backup process failed because of a parameter error. This message indicates a programming
problem within RDF. The message includes the status word returned by the CHECKPOINT
procedure.
Effect The backup process is stopped, and a new one is created after about 15 seconds.
Recovery This is an informational message; no recovery is required.
You should, however, contact your service provider and explain that this error occurred.
720
Audit trail file single block missing
Cause The extractor detected an error in block sequence numbers in the TMF audit trail.
The sequence numbers show that a single block is missing.
Effect This is only a warning. Normal processing continues.
It is possible, however, that the backup database is no longer consistent with the primary
database.
Recovery This is an informational message; no recovery is required.
Tell your database administrator that this error occurred. The database administrator should
consider checking the synchronization of the primary and backup databases.
721
Audit trail multiple blocks missing
Cause The extractor detected an error in block sequence numbers in the TMF audit trail.
The sequence numbers show that multiple blocks are missing.
RDF Messages 347