RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect This is only a warning. Normal processing continues.
It is possible, however, that the backup database is no longer consistent with the primary
database.
Recovery This is an informational message; no recovery is required.
Tell your database administrator that this error occurred. The database administrator should
consider checking the synchronization of the primary and backup databases.
722
Waiting for audit-trail file restoration, SNO sno
sno
is the sequence number of the audit trail for which the extractor is waiting.
Cause The extractor has requested that the specified audit-trail file be restored.
Effect The extractor waits until the audit-trail file is restored.
Recovery If you are dumping audit trails to tape and you have already mounted the correct
tape, then this is an informational message. If you have not mounted the tape, check the EMS
log to see what tape the TMF product requires and mount that tape.
723
Irrecoverable error on audit-trail file filename at RBA rba
filename
is the name of the audit-trail file that contained the error.
rba
is the relative byte address where the error occurred in the audit-trail file.
Cause The extractor encountered an irrecoverable error at the designated relative byte
address (rba) in the designated TMF audit-trail file. This message indicates an internal RDF
or TMF error.
Effect This is a catastrophic error; the extractor abends, and RDF stops.
Recovery Because this message indicates a system error, you should preserve the indicated
audit-trail file for further analysis by your service provider.
724
RDF TAKEOVER has completed successfully
Cause The purger has determined that all updaters have processed through to the end of
the image trail and the RDF TAKEOVER operation has completed.
Effect Normal purger shutdown processing continues. When the purger stops, the
TAKEOVER operation will be finished.
Recovery This is an informational message; no recovery is required.
725
RDF TAKEOVER has not completed
Cause One of two conditions caused this event.
• UPDATE was OFF when the purger began the RDF TAKEOVER operation.
• At least one updater process terminated prematurely, without processing through to the
end of the image trail. The premature updater shutdown might have resulted from a
double CPU failure or a STOP command entered manually from TACL. Because the
updater might not have processed all image audit, the RDF TAKEOVER operation cannot
be considered complete. Scan the EMS event log for RDF message 726: this message
identifies the updater process that did not complete TAKEOVER processing.
Effect Normal purger shutdown processing continues.
348 Messages