RDF System Management Manual for H-Series RVUs (RDF 1.8)

Recovery If UPDATE was OFF at the time of the RDF TAKEOVER, then a second RDF
TAKEOVER operation is automatically started, and no recovery is required. Otherwise, you
must restart the takeover operation with the RDFCOM TAKEOVER command.
726
Updater did not complete the TAKEOVER vol => vol
vol => vol
are the volume on the primary node that the updater is protecting and the corresponding
volume to which it is writing on the backup node.
Cause The RDF purger has determined that the updater process indicated in this message
did not complete RDF TAKEOVER processing. That updater might have stopped prematurely
because of a double CPU failure or a STOP command entered manually from TACL.
Effect The updater responsible for the volume named in the message did not complete RDF
TAKEOVER processing.
Recovery When you have determined why the updater stopped prematurely and you have
corrected the problem, you must re-issue the RDFCOM TAKEOVER command.
727
Audit-trail file missing SNO sno
sno
is the sequence number of the missing audit-trail file.
Cause The specified file should exist on disk, but it does not.
Effect The extractor abends.
Recovery This is an internal error. Contact your service provider.
728
Backup Processor Down
Cause The CPU of the backup process of a NonStop process pair failed.
Effect The primary process continues to run, but not in fault-tolerant mode.
Recovery Reload the downed processor. The backup process is re-created when the processor
is reloaded.
729
Attempt to alter process priority failed priority
priority
is the priority requested for the process.
Cause An attempt to alter the priority of an RDF process to the indicated priority has
failed.
Effect The process continues to run at its current priority.
Recovery This is an informational message; no recovery is required.
Reissue the ALTER command.
730
Process priority altered priority
priority
is the priority requested for the process.
Cause The operator successfully changed the priority of an RDF process to priority.
Effect The process runs at the new priority.
Recovery This is an informational message; no recovery is required.
RDF Messages 349