RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The updater delays for 30 seconds and then tries to obtain the information again.
Recovery If the specified file is an Enscribe file, you must create the file on the backup system.
You should always create SQL objects on the backup system first and then create them on the
primary system.
737
RDF extractor establishing synch
Cause When the extractor is starting or restarting, it must send a request to the receiver to
obtain its starting position in the TMF audit trail. The extractor issues event 737, indicating
that the extractor is attempting to become synchronized with the receiver by requesting its
starting position.
Effect The extractor attempts to become synchronized with the receiver.
Recovery This is an informational message; no recovery is required.
738
RDF extractor synch established SNO sno RBA rba
sno
is the sequence number of the TMF Master Audit Trail (MAT) for which the synchronization
point was established.
rba
is the relative byte address of the synchronization point.
Cause This message indicates that the receiver has sent the extractor a starting position in
the TMF audit trail, and that the extractor has thereby become synchronized with the receiver.
Effect Extractor is synchronized with the receiver.
Recovery This is an informational message; no recovery is required.
739
File creation failed. Error error On filename
error
is the file-system error number that identifies the specific error.
filename
is the name of the file that the updater tried to create.
Cause An updater was unable to create a file on its UPDATEVOLUME disk. The message
includes both the file-system error number and the name of the file the updater attempted to
create.
Effect See Table 5-3 (page 123) to determine the effect of this error.
Recovery See Table 5-3 (page 123) to determine the appropriate recovery actions.
740
Create for unprotected RDF volume failed volume. Error error
volume
is the name of the volume that could not be found among those protected by RDF.
error
is the file-system error number that identifies the specific error.
Cause This warning message is issued when a create operation for the primary partition of
a partitioned file must map one or more of the file’s secondary partitions to a volume that does
not match any of the volumes protected by RDF on the primary node. This message is also
issued when the creation of a file with alternate keys is attempted and the corresponding
alternate key file does not match any of the volumes protected by RDF on the primary node.
Effect The create operation fails and is skipped.
352 Messages