RDF System Management Manual for H-Series RVUs (RDF 1.8)

If the process is an updater, then the backup database is synchronized for the volume protected
by the particular updater.
Recovery This is an informational message; no recovery is required.
783
RDF receiver process is not running
Cause The monitor or extractor process could not open the remote receiver process after a
communications failure.
Effect If the monitor or extractor process receives a file-system error 14 (process does not
exist), RDF will shut down on the primary node.
Recovery If RDF was stopped on the remote node by a STOP RDF command while the
communications lines were down, simply restart RDF by issuing a START RDF command.
784
Shutdown pending STOP UPDATE, TIMESTAMP timestamp
timestamp
is the specified timestamp.
Cause The process has received notice that an RDFCOM STOP UPDATE, TIMESTAMP
command was executed.
Effect Each updater applies only audit data associated with transactions that committed
prior to the specified timestamp.
Recovery This is an informational message; no recovery is required.
785
Redo pass ending on reaching timestamp timestamp
timestamp
is the timestamp specified previously by an operator in an RDFCOM STOP UPDATE,
TIMESTAMP timestamp command.
Cause A STOP UPDATE, TIMESTAMP timestamp command has been issued and the
updater has completed its redo pass.
Effect The updater is ready to commence its undo pass.
Recovery This is an informational message; no recovery is required.
786
STOP SYNCH message received
Cause The extractor has received notification of the RDFCOM STOP SYNCH command.
This event represents the start of part one of phase 1 of the extractor’s work in an online
database synchronization operation.
Effect When the extractor encounters the next TMP control point record in the MAT, it enters
phase one, part 1 processing.
Recovery This is an informational message; no recovery is required.
787
Image trail file position error error on filename. SNO sno RBA rba
error
is the error number that identifies the specific error.
filename
is the name of the image trail file that contained the error.
sno
is the sequence number where the error occurred.
RDF Messages 361