RDF System Management Manual for H-Series RVUs (RDF 1.8)

rba
is the relative byte address where the error occurred.
Cause The receiver or an updater has encountered the indicated error while attempting to
position into an image file.
Effect The process abends.
Recovery Correct the problem that caused the error and then restart RDF.
788
ALLOCATESEGMENT failure. Returned status status
status
is a status code reflecting information about the error.
Cause An RDF process received an error from the ALLOCATESEGMENT system procedure.
Effect This is a catastrophic error; the process abends, and RDF stops.
Recovery See the description of the ALLOCATESEGMENT procedure in the Guardian
Procedure Calls Reference Manual to determine the cause of the failure. Once the underlying
cause is corrected, you can restart RDF.
789
CHECKALLOCATESEGMENT failed with error error
error
is the error number that identifies the specific error.
Cause The primary process of an RDF process pair received an error from the
CHECKALLOCATESEGMENT system procedure.
Effect This error is not fatal; processing continues. The backup process is stopped and then
re-created later.
Recovery See the description of the CHECKALLOCATESEGMENT procedure in the Guardian
Procedure Errors and Messages Manual to determine the cause of the failure. Some corrective
action might be required for the backup process to be re-created without repeated failures.
The most likely cause is insufficient space available for swapping on the swap volume.
790
Backup process created in processor cpu
cpu
is the CPU in which the backup process was created.
Cause The backup process of a process pair was created in the specified processor.
Effect The primary process will now run in fault-tolerant mode.
Recovery This is an informational message; no recovery is required.
796
Image file creation error error on filename
error
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause The receiver or purger process could not create the specified file due to the specified
file-system error.
Effect This is a catastrophic error; the process abends and RDF stops.
Recovery Correct the underlying condition, then restart RDF.
362 Messages