RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The RDF process stops normally.
Recovery This is an informational message; no recovery is required.
810
Shutting down in response to STOP TMF, timestamp timestamp
timestamp
is the time of the shutdown.
Cause The operator issued a TMFCOM STOP TMF command at the primary node.
timestamp is the time of that shutdown.
Effect The RDF process stops normally.
Recovery This is an informational message; no recovery is required.
811
RDF TAKEOVER initiated
Cause The operator issued a TAKEOVER command.
Effect RDF starts a TAKEOVER operation.
Recovery This is an informational message; no recovery is required.
812
Error error communicating with procname
error
is the file-system error number that identifies the specific error.
procname
is the name of the process with which the updater cannot communicate.
Cause The updater encountered a file-system error while attempting to communicate with
the receiver or purger. The file-system error number and the name of the receiver or purger
are included in the message.
Effect This is a catastrophic error; the updater abends, and RDF will abort.
Recovery Determine the cause of the error. If the receiver or purger did not abend, correct
the condition, and restart RDF.
813
Concurrent file opens exceed capacity
Cause This message is reported by updater processes when the number of concurrent file
opens exceeds the capacity of the table in which the updater maintains information about file
opens.
Effect The updater will close idle files (if any) and continue. If there are no idle files, then
the updater will close all files and establish a restart point from which processing can continue.
In the latter case, there will be a performance degradation.
Recovery This is an informational message. If the condition persists, however, your database
administrator should consider moving some of the files protected by TMF on the primary
node volume to another volume, and adding another updater to back up the new volume. If
you do that, you must synchronize the affected volumes on the primary and backup nodes.
814
Backup process takeover in processor cpu
cpu
is the number of the processor in which the backup process is now running.
Cause The primary process has stopped for some reason, perhaps a cpu failure.
Effect The backup process of the process pair has taken over.
366 Messages