RDF System Management Manual for H-Series RVUs (RDF 1.8)

877
First network transaction to be undone: %num num num num
%num num num num
identifies a network transaction.
Cause This is the first transaction that requires network undo with respect to local processing.
Note, however, that some transactions preceding it might also require undo for business
consistency across all backup nodes. The transid is listed in internal format.
Effect This is an internal event. There is no effect.
Recovery This is an informational message for historical purposes about a network undo
pass. No recovery is required.
878
Invalid image filename or filecode [ANSI-object-type ANSI-name, Partition
partition-id,] file filename
ANSI-object-type
is the ANSI object type (for example, table, index, and so on.). SeeTable 16-1 (page 295) for
a list of possible ANSI object types.
ANSI-name
is the ANSI name of the SQL/MX object that encountered the error.
partition-id
is the partition ID of the SQL/MX object that encountered the error.
filename
is the Guardian filename of the file that encountered the error.
Cause The purger process has found a file or table in an image trail subvolume where the
filename either does not contain a valid file-sequence number, or the filecode is not 720.
Effect The purger process will not process any more files in that particular subvolume. The
operation will be attempted again after PURGETIME minutes.
Recovery The file or table being reported was not created by RDF and is not part of the RDF
environment. It must be manually purged or renamed out of the image subvolume before the
purger process can continue normal processing.
879
Audit attribute not set for [ANSI-object-type ANSI-name, Partition
partition-id,] file filename
ANSI-object-type
is the ANSI object type (for example, table, index, and so on.). SeeTable 16-1 (page 295) for
a list of possible ANSI object types.
ANSI-name
is the ANSI name of the SQL/MX object that encountered the error.
partition-id
is the partition ID of the SQL/MX object that encountered the error.
filename
is the Guardian filename of the file that encountered the error.
Cause The specified table or file on the backup system does not have its audit attribute set.
Effect The updater waits until the audit attribute is turned on.
Recovery Turn on the audit attribute for the specified table or file.
880
Takeover issued during a stop-update-to-time operation
Cause A TAKEOVER command was issued while a stop-update-to-time operation was in
progress.
RDF Messages 379