RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The trigger process is started.
Recovery This is an informational message; no recovery is required.
914
Trigger process completed. [ Completion Code: num ] [ Termination Text:
text ] [ The process is abended. ]
num
is the completion code.
text
is the termination text.
Cause The purger has seen that the user specified trigger process has stopped. The message
might include completion code and/or termination text information that indicates why the
process stopped. If the process abended that will also be indicated.
Effect The trigger process is stopped.
Recovery There is no set recovery procedure. See the Guardian Procedure Errors and
Messages Manual for a description of completion codes.
915
Drain operation complete but a primary volume is down
Cause A STOP RDF, DRAIN or STOP RDF, REVERSE command has completed but RDF
has detected that a volume on the primary node is down.
Effect Any transactions that touched the affected volume that were active when the volume
went down are unresolved (on both the primary and backup systems). If this event is the result
of a STOP RDF, REVERSE, the REVERSE trigger is not executed.
Recovery Repair and bring up the affected volume, restart RDF and repeat the operation.
916
File create error err on filename
err
is a Guardian error number.
filename
is the name of the file that could not be created.
Cause The process that reported this event could not create the specified file. The attempt
to create the file returned the specified Guardian error.
Effect The file is not created and the effect on RDF depends on which process reported the
error and on what it was attempting to do at the time.
Recovery If possible, the user should attempt to correct the underlying problem or seek
assistance from their service provider.
917
Shared access DDL operation encountered while DRAIN or REVERSE is pending
Cause A STOP RDF, DRAIN (or REVERSE) operation is being processed and the RDF
extractor encountered a shared access DDL operation in the TMF audit trail.
Effect These two operations cannot be processed concurrently, which causes RDF to abort.
Recovery Restart RDF and the shared access DDL operation will be processed as normal.
Having completed the shared access DDL operation, a new STOP RDF, DRAIN (or REVERSE)
command can be issued.
918
STOP TMF record encountered while DRAIN or REVERSE is pending
386 Messages