RDF System Management Manual for H-Series RVUs (RDF 1.8)

Recovery Either shut down RDF and reenter the ALTER command, or select another
command to enter.
ALTER of this element cannot be performed with updaters running
Cause An ALTER command was issued for a non-runtime ALTER option.
Effect The command fails.
Recovery Stop updating by entering the STOP UPDATE command through RDFCOM, and
then reenter the ALTER command.
ALTER RECEIVER RDFVOLUME is no longer supported
Cause RDFCOM no longer supports this command.
Effect The command fails.
Recovery Select another command.
Ambiguous timestamp for operation
Cause RDFCOM could not resolve an ambiguous timestamp after a change to Local Civil
Time (LCT) when the LCT was changed relative to Greenwich Mean Time (GMT). In this
situation, two LCTs map to the same GMT and it is impossible to determine the correct intended
time.
This problem typically occurs in Autumn, when the clock is set back from Daylight Savings
Time. If you specify an RDF initialization timestamp between 1:00AM and 2:00AM on that
day, the intended time is ambiguous. Did you mean before the clock was turned back or after?
To eliminate this ambiguity, a specified RDF initialization timestamp in this one-hour interval
is reported as an error.
Effect Initialization is aborted.
Recovery Reinitialize RDF specifying a timestamp that is earlier than the ambiguous time.
A partial RDF TAKEOVER has completed
Cause You issued a STATUS RDF command after a TAKEOVER command has completed,
but one or more updater processes had terminated prematurely and was therefore unable to
process all applicable image audit data.
Effect The primary and backup databases are inconsistent.
Recovery To determine which updaters terminated prematurely, examine the EMS event
log for error number 726. Then, reissue the TAKEOVER command.
A required attribute for network master is missing
Cause You must specify the PrimarySystem, BackupSystem, RemoteControlSubvolume,
and PnetTxVolume attributes for each Network record in the configuration of your network
master, but you are missing one or more or more of these network attributes.
Effect The configuration command fails.
Recovery Set the missing fields and add the record.
A required attribute for a non network master is missing
Cause You must specify the PrimarySystem, BackupSystem, and RemoteControlSubvolume
for the network master of your RDF network.
Effect The configuration command fails.
Recovery Set the missing fields and add the record.
A TAKEOVER operation has not completed on the local system
Cause You tried to execute the COPYAUDIT command, but the RDF TAKEOVER operation
has not completed on the local system.
Effect The COPYAUDIT command is aborted.
390 Messages