RDF System Management Manual for H-Series RVUs (RDF 1.8)

error#
is the file-system error number that identifies the specific error.
filename
is the name of the updater maplog specified in the updater configuration.
Cause Purgedata operation returned an error when RDFCOM tried to clean the updater
maplog file when an ADD VOLUME, ALTER VOLUME, or START RDF command was being
executed.
Effect The command fails.
Recovery See the Guardian Procedure Errors and Messages Manual for a description of the
recovery actions for the file-system error. Correct the error indicated by error#, then reenter
the command.
Error error# on process info attempt
error#
is the file-system error number that identifies the specific error.
Cause The COPYAUDIT command encountered the specified error while attempting to
process information about the current RDFCOM session.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. Take appropriate corrective action, and then reissue the COPYAUDIT
command.
Error error# on setmode for imagefile ownership
error#
is the file-system error number that identifies the specific error.
Cause The COPYAUDIT command encountered the specified error while attempting to
perform a SET MODE operation to set the ownership for a new image file on the local image
trail.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. Take appropriate corrective action, and then reissue the COPYAUDIT
command.
Error error# on setmode for imagefile security
error#
is the file-system error number that identifies the specific error.
Cause The COPYAUDIT command encountered the specified error while attempting to set
the security for a new image file on the local image trail where it is storing new audit.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. Take appropriate corrective action, and then reissue the COPYAUDIT
command.
Error error# on setmode for large transfers
error#
is the file-system error number that identifies the specific error.
Cause The COPYAUDIT command encountered the specified error while attempting to
perform a SET MODE operation to enable large transfers of data.
Effect The COPYAUDIT command aborts.
RDFCOM Messages 397