RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The COPYAUDIT command aborts.
Recovery There might be no recovery for this problem. You must perform the database
synchronization without the help of RDFCOM.
IMAGETRAIL for IMAGEVOLUME vol-name does not exist
vol-name
is the image trail volume for which the image trail does not exist.
Cause You tried to add an updater, but have not yet added an image trail for the updater’s
volume.
Effect The ADD command fails.
Recovery Add the image trail. Then add the updater.
IMAGETRAIL for IMAGEVOLUME vol-name does not exist or the atindex of
the IMAGEVOLUME does not match the updater’s atindex
vol-name
is the image trail volume
Cause You tried to add an updater for a particular ATINDEX, but there is no imagetrail
configuration for that value. Either you have not yet added the imagetrail or you added it with
a different ATINDEX.
Effect The ADD command fails.
Recovery Review and revise your RDF configuration.
IMAGETRAIL is already in use by Receiver
Cause You tried to add a secondary image trail, but the volume you specified for that trail
is already being used for receiver’s RDFVOLUME.
Effect The command fails.
Recovery Select a different volume for the secondary image trail.
Imagetrails cannot be added if RDF has been started after initialization
Cause You tried to add a secondary image trail after RDF has been started. However, you
can only add secondary image trails after RDF has been initialized and before it has been
started for the first time following this initialization.
Effect The command fails.
Recovery If you must add an image trail, you must stop TMF, allow RDF to catch up to the
shutdown, and then reinitialize and reconfigure RDF.
IMAGETRAIL volume-name has already been added
volume-name
is the name of the volume you specified for the image trail.
Cause You tried to add a secondary image trail on the volume volume-name, but an image
trail has already been added for this volume.
Effect The command fails.
Recovery Select a different volume for the secondary image trail.
IMAGETRAIL volume-name is not used by any updater
volume-name
is the name of the image trail.
Cause While validating your configuration, RDFCOM determined that the image trail on
the volume volume-name is not referenced by any updater processes.
Effect The validation operation aborts.
Recovery Delete this image trail
RDFCOM Messages 401