RDF System Management Manual for H-Series RVUs (RDF 1.8)

IMAGETRAIL volume-name record not found; DELETE aborted
volume-name
is the name of the secondary image trail that was specified in the command.
Cause You tried to delete a secondary image trail that does not exist.
Effect The command fails.
Recovery Select a different secondary image trail to delete, or select another command.
IMAGETRAIL VOLUME volume-name does NOT exist
volume-name
is the name of the volume.
Cause While validating your configuration, RDFCOM determined that the volume for this
image trail does not exist on the backup node.
Effect The validation operation aborts.
Recovery Delete this image trail volume and all updaters that use it.
IMAGETRAIL VOLUME volume-name is not a disk volume
volume-name
is the name of the volume.
Cause While validating your configuration, RDFCOM determined that volume-name
does not refer to a disk device on the backup node.
Effect The validation operation aborts.
Recovery Delete this image trail volume and all updaters that refer to it.
IMAGEVOLUME volume-name is not a legal volume name
volume-name
is the name of the volume.
Cause The SET VOLUME IMAGEVOLUME command specified an invalid volume name.
Effect The command fails.
Recovery Reenter the command, using a correct volume name.
Inconsistent network options are not allowed
Cause You have attempted to add the RDF configuration record with the RDF
NetworkMaster attribute on but the Network attribute off.
Effect The configuration command fails.
Recovery You must determine whether you are in an RDF network or not.
Initialization point for timestamp has been found
timestamp
is an INITTIME timestamp specified previously by an operator in an RDFCOM INITIALIZE
RDF command.
Cause You are attempting to initialize RDF to a timestamp that is earlier than the current
time, and database synchronization is not involved. A record whose timestamp is less than
timestamp has been found.
Effect The RDFCOM INITIALIZE RDF command continues.
Recovery This is an informational message; no recovery is required.
Initialization timestamp is timestamp
timestamp
is an INITTIME timestamp specified previously by an operator in an RDFCOM INITIALIZE
RDF command.
402 Messages