RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect RDF does not start.
Recovery Add a network record to describe the network master subsystem.
MONITOR Record exists, use ALTER MONITOR
Cause An ADD MONITOR command was issued when the configuration file already
contained a monitor record.
Effect The command fails.
Recovery No recovery is required if you want to use the existing monitor process as
configured. If you want to change any of the monitor’s configuration options, however, enter
an ALTER MONITOR command that specifies those changes.
MONITOR record NOT found
Cause The INFO command could not find a monitor record in the configuration file.
Effect The command fails.
Recovery Alter the configuration to include the monitor process.
Network options are only available with the RDF/IMPX product
Cause You have attempted to specify configuration information for an RDF network, but
you do not have an RDF/IMPX license.
Effect The configuration command fails.
Recovery If you need to run in an RDF network, you need to obtain the RDF/IMPX license
and product.
NETWORK record can only be added into a networked subsystem
Cause An ADD NETWORK command was entered but the RDF NETWORK parameter is
set OFF.
Effect The ADD NETWORK command is rejected.
Recovery Reconfigure RDF to have the RDF NETWORK parameter set ON.
Network record not found
Cause The current RDF subsystem is configured in an RDF network, but a network record
has not been added.
Effect Validation fails.
Recovery You must add the appropriate NETWORK configuration record.
Network synch file ZRDFNETX file must be INCLUDED
Cause An INCLUDE pattern has been specified that will cause audit information associated
with the NetSynch data file to be filtered out.
Effect RDF can not be started.
Recovery Correct the VOLUME INCLUDE associated with the PNETTXVOLUME so that
the file $volume.control-subvolume.ZRDFNETX is included.
Network synch file ZRDFNETX must not be EXCLUDED
Cause An EXCLUDE pattern has been specified which will case audit associated with the
NetSynch data file to be filtered out.
Effect RDF can not be started.
Recovery Correct the VOLUME EXCLUDE associated with the PNETTXVOLUME so that
the EXCLUDE pattern does not exclude the file $volume.control-subvolume.ZRDFNETX.
No EXTRACTOR is Configured
Cause The RDF configuration file is invalid.
Effect The validation fails.
406 Messages