RDF System Management Manual for H-Series RVUs (RDF 1.8)

Recovery Alter the configuration to include the extractor.
No EXTRACTOR is configured for ATINDEX atindex
Cause You added a receiver with the specified ATINDEX, but there is no extractor with
that value.
Effect The validation fails.
Recovery Add an extractor with the same ATINDEX value or delete the particular receiver.
No RECEIVER is configured for ATINDEX atindex
Cause You added an extractor with the specified ATINDEX, but there is no receiver with
that value.
Effect The validation fails.
Recovery Add a receiver with the same ATINDEX value or delete the particular extractor.
Not able to open the MAPFILE filename, error error#
filename
is the name of the updater mapfile specified in the updater configuration.
error#
is the file-system error number that identifies the specific error.
Cause RDFCOM was not able to open the updater mapfile when an ADD VOLUME, ALTER
VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION command was
being executed.
Effect The command fails.
Recovery See the Guardian Procedure Errors and Messages Manual for a description and recovery
actions for the file-system error. Correct the error indicated by error#, then, reenter the
command.
No image files could be found in the imagetrail on
volume-name.subvolume-name
volume-name
is the name of the image trail’s volume
subvolume-name
is the name of the image trail’s subvolume.
Cause The COPYAUDIT command could not find any image files on the remote image trail.
This problem indicates that the receiver’s RETAINCOUNT value was probably not set high
enough and that, as a result, some image files on the remote system were purged.
Effect The COPYAUDIT command aborts.
Recovery There is no recovery action. The COPYAUDIT command cannot be executed
because image files needed for this command were already purged from the remote system.
No MONITOR is Configured
Cause The RDF configuration file is invalid.
Effect The validation fails.
Recovery Alter the configuration to include the monitor.
No PCB available
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The command fails.
Recovery Check system resource utilization. When resources become available, reenter the
command.
No RECEIVER is Configured
RDFCOM Messages 407