RDF System Management Manual for H-Series RVUs (RDF 1.8)

Recovery See the Guardian Procedure Errors and Messages Manual for a description of the
recovery actions for the file-system error. Correct the error indicated by error#, then reenter
the command.
Open error error# on MAPLOG file filename
error#
is the file-system error number that identifies the specific error.
filename
is the name of the updater maplog specified in the updater configuration.
Cause RDFCOM was not able to open the updater maplog when an ADD VOLUME, ALTER
VOLUME, START RDF, or START UPDATE command was being executed.
Effect The command fails.
Recovery See the Guardian Procedure Errors and Messages Manual for a description of the
recovery actions for the file-system error. Correct the error indicated by error#, then reenter
the command.
Operation can only be performed on the BACKUPSYSTEM \backup
backup
is the name of the backup node that can perform the operation.
Cause The command can be issued only at the backup system.
Effect The command fails.
Recovery Enter another command.
Operation can only be performed on the PRIMARYSYSTEM \primary
primary
is the name of the primary node that can perform the operation.
Cause The command can be issued only at the primary node.
Effect The command fails.
Recovery Enter another command.
Operation is NOT allowed when RDF is running
Cause The command is not allowed while RDF is running.
Effect The command fails.
Recovery Enter another command, or shut down RDF and reenter this command.
Operation must be performed on the PRIMARYSYSTEM \primary or BACKUPSYSTEM
\backup
primary
is the name of the primary node that can perform the operation.
backup
is the name of the backup node that can perform the operation.
Cause The command was issued at a third system, which is not allowed.
Effect The command fails.
Recovery Enter another command, or reenter this command at the specific primary or backup
node reflected by this message.
Please wait while RDF searches for the specified shutdown timestamp
Cause You entered an INITIALIZE RDF command that attempted to initialize RDF at a
specific TMF shutdown timestamp, and responded YES or Y to the subsequent confirmation
prompt, directing the subsystem to proceed with the initialization.
RDFCOM Messages 409