RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect RDFCOM reads backward through the MAT in search of a TMF shutdown record
with the same timestamp you specified.
Recovery This is an informational message; no recovery is required. You can terminate the
operation at any time by pressing the BREAK (or equivalent) key.
PNETTXVOLUME volume for ctrl-subvol must be protected by a MAT
based-updater
volume
is the name of an RDF data volume.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause The specified volume for the RDF subsystem with the specified control subvolume
is not configured to the Master Audit Trail (MAT).
Effect Validation fails.
Recovery The PNETTXVOLUME must be configured to the Master Audit Trail (MAT). You
need to reconfigure your network master and the subsystem with the specified control
subvolume.
PNETTXVOLUME volume is not configured to a MAT based updater
volume
is the name of an RDF data volume.
Cause The specified PNETTXVOLUME is not configured to a MAT based updater.
Effect Validation fails.
Recovery You must reconfigure your network master and possibly your local configuration.
Position error error# on file remote-config-file
error#
is the file-system error number that identifies the specific error.
remote-config-file
is the name of the remote configuration file.
Cause The COPYAUDIT command encountered the specified error while attempting to
position into the remote configuration file.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
Position error error# on local image file
error#
is the file-system error number that identifies the specific error.
Cause The COPYAUDIT command encountered the specified error while attempting to
position into a local image file on the local image trail.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
Position error error# on new image file filename
error#
is the file-system error number that identifies the specific error.
410 Messages