RDF System Management Manual for H-Series RVUs (RDF 1.8)

Program File Error: error# on progfile
error#
is the error number that identifies the specific error.
progfile
is the name of the program file on which the error was encountered.
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The START RDF or TAKEOVER operation is aborted.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
RDF already in TAKEOVER processing
Cause The operator issued a TAKEOVER command at the backup node while RDF was
performing a TAKEOVER operation.
Effect The last TAKEOVER command is ignored.
Recovery This is an informational message; no recovery is required.
RDF configuration file is not open, use OPEN command
Cause The configuration file must be open before any RDFCOM commands other than
OPEN or OBEY can be executed.
Effect The attempted operation is aborted.
Recovery Open the configuration file with the OPEN command.
RDF has not been initialized.
Cause You issued an INITIALIZE RDF command, but entered NO or N in response to the
subsequent confirmation prompt for continuing the initialization process.
Effect RDF is not initialized.
Recovery This is an informational message; no recovery is required.
RDF LOGFILE filename NOT a legal filename on system \node
filename
is the name of the nonexistent EMS collector (RDF log file).
node
is the name of the system where the collector name is invalid.
Cause The RDF configuration file is invalid: a nonexistent EMS collector was specified.
Effect The ADD RDF command fails.
Recovery Specify a valid EMS collector name in a SET RDF command, and then reenter the
ADD RDF command.
RDF network subsystem ctrl-subvol has not been validated
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause Your are attempting to validate the network master of your RDF network before you
have validated all non network master subsystems.
Effect Validation fails.
Recovery Validate all your non network master subsystems and then validate your local
subsystem.
RDF (\primary -> \backup) is NOT running
Cause A STATUS RDF or STOP RDF command was issued while RDF was stopped.
412 Messages