RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The attempted command is aborted.
Recovery Contact the Global Mission Critical Solution Center (GMCSC) or your service
provider.
RDFCOM is asking the TMP to restore the file. If the file was previously
dumped to tape, watch for the TMP to tell you to mount the appropriate
tape.
Cause In response to a prompt, you requested RDFCOM to trigger restoration of an audit-trail
file. If the file has been previously dumped to tape, you must now watch the EMS log for the
TMP’s prompt to mount the appropriate tape.
Effect The restore operation proceeds.
Recovery When the tape-mount prompt appears in the EMS log, mount the tape.
RDFNETS process only allowed for RDF network master configuration.
Cause You have attempted to add the NetSynch process to your configuration, but your
configuration is not the network master.
Effect The configuration command fails.
Recovery Do not add this record.
RDFVOLUME in network master record is incorrect rdf-vol.
rdf-vol
is the RDFVOLUME specified in the network record of the network master.
Cause The RDFVOLUME of the current RDF configuration does not match the value specified
in the network record of the network master.
Effect Validation fails.
Recovery You must reconfigure your network master and possibly your local configuration.
RDFVOLUME in network master record is invalid.
Cause The RDFVOLUME of the current RDF configuration is invalid in the network record
of the network master.
Effect Validation fails.
Recovery You must reconfigure your network master and possibly your local configuration.
RDFVOLUME is not allowed for an aux receiver. Auxiliary receivers do
not have an RDFVOLUME.
Cause You tried to add an auxiliary receiver for which you had specified an RDFVOLUME.
Effect The ADD command fails.
Recovery Issue a RESET RECEIVER command, and then reconfigure the particular receiver
without specifying an RDFVOLUME.
Read error error# on file remote-config-file
error#
is the file-system error number that identifies the specific error.
remote-config-file
is the name of the remote configuration file.
Cause The COPYAUDIT command encountered the specified error while attempting to
read the remote configuration file.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT
command. Otherwise, contact your service provider.
414 Messages