RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The command fails.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
RECEIVER RDFVOLUME device is NOT a disk volume
device
is the name of the non-disk device.
Cause The RDF configuration file is invalid.
Effect The validation of the receiver fails.
Recovery Specify a valid disk volume.
RECEIVER RDFVOLUME volume-name does NOT exist
volume-name
is the name of the nonexistent RDFVOLUME file.
Cause The RDF configuration file is invalid.
Effect The validation of the receiver fails.
Recovery Specify a valid disk volume.
RECEIVER Record does not exist
Cause You tried to add a secondary image trail before adding the receiver’s configuration
record.
Effect The command fails.
Recovery Add the receiver’s record. Then, add the secondary image trail.
RECEIVER record exists, use ALTER RECEIVER
Cause An ADD RECEIVER command was issued when the configuration file already
contained a receiver record.
Effect The command fails.
Recovery No recovery is required if you want to use the existing receiver process as it is
configured. If you want to change any of the receiver’s configuration options, however, enter
an ALTER RECEIVER command that specifies those changes.
RECEIVER record NOT found.
Cause The INFO command could not find a receiver record in the configuration file.
Effect The command fails.
Recovery Alter the configuration to include a receiver process.
Receiver record not found for subsystem ctrl-subvol.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause RDFCOM was unable to read the receiver record for the RDF subsystem with the
specified control subvolume.
Effect Validation fails.
Recovery Determine why the receiver record for the subsystem cannot be obtained.
RECEIVER Record with ATINDEX atindex does not exist.
Cause You tried to add an imagetrail with the specified ATINDEX, but there is no receiver
with that value.
Effect The ADD command fails.
416 Messages