RDF System Management Manual for H-Series RVUs (RDF 1.8)

Recovery You must purge $SYSTEM.name.* on the primary system before you can retry
the INITIALIZE RDF command. Before doing so, however, be sure that the existing files do
not belong to a different RDF configuration that is still valid.
The EXTRACTOR must be a named process
Cause You must specify a process name for the extractor process before issuing an ADD
command.
Effect The start command fails.
Recovery You must reconfigure RDF with a named extractor process.
The last record in the local imagetrail on volume-name.subvolume-name
could not be found in the remote trail
volume-name
is the name of the image trail’s volume
subvolume-name
is the name of the image trail’s subvolume.
Cause The COPYAUDIT command could not find the last record in the local image trail on
the remote image trail. This problem indicates that the receiver’s RETAINCOUNT value was
probably not set high enough and that, as a result, some image files on the remote system were
purged.
Effect The COPYAUDIT command aborts.
Recovery There is no recovery action. The COPYAUDIT command cannot be executed
because image files needed for this command were already purged from the remote system.
The MAPFILE filename is not found
filename
is the name of the updater mapfile specified in the updater configuration.
Cause RDFCOM could not find the updater mapfile when an ADD VOLUME, ALTER
VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION command was
being executed.
Effect The command fails.
Recovery Provide an existing mapfile and reenter the command.
The MAPFILE filename should be an edit file
filename
is the name of the updater mapfile specified in the updater configuration.
Cause RDFCOM found that the updater mapfile is not an EDIT format file when an ADD
VOLUME, ALTER VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION
command was being executed.
Effect The command fails.
Recovery Provide an edit file and reenter the command.
The MAPLOG file filename could not be created: error error#
filename
is the name of the updater maplog specified in the updater configuration.
error#
is the file-system error number that identifies the specific error.
Cause Create operation returned an error when RDFCOM tried to create the updater maplog
file when an ADD VOLUME, ALTER VOLUME, START UPDATE, or START RDF command
was being executed.
Effect The command fails.
422 Messages