RDF System Management Manual for H-Series RVUs (RDF 1.8)

Recovery See the Guardian Procedure Errors and Messages Manual for a description of the
recovery actions for the file-system error. Correct the error indicated by error#, then reenter
the command.
The MAPLOG file filename should be an edit file
filename
is the name of the updater maplog specified in the updater configuration.
Cause RDFCOM found that the updater maplog is not an edit format file when an ADD
VOLUME, ALTER VOLUME, START RDF, or START UPDATE command was being executed.
Effect The command fails.
Recovery Provide an edit file and reenter the command.
The MAT file with sequence number seq-num is not currently on disk.
RDFCOM can trigger the restoration of the file, but only as a waited
operation and you must mount the tapes Do you want RDFCOM to restore
the file?
seq-num
is the sequence number of the MAT file.
Cause While searching for a TMF shutdown timestamp to use to initialize RDF, RDFCOM
found that the audit-trail file with the specified sequence number is not currently available.
If you respond to the prompt with YES or Y, RDFCOM directs the TMP to begin restoring this
file.
NOTE: If the file was dumped to tape, you must wait for the TMP to prompt you to mount
the tape. This mount request is logged in the EMS log.
If you respond with NO or N, then RDFCOM aborts the initialization attempt.
Effect RDFCOM waits for your response to the prompt.
Recovery Respond YES or Y, or NO or N, to the prompt.
The MONITOR must be a named process.
Cause You must specify a process name for the monitor process before issuing an ADD
command.
Effect The start command fails.
Recovery You must reconfigure RDF with the named monitor process.
The number of physical UPDATEVOLUMES exceeds 255. RDF/IMPX is required
for this many volumes.
Cause RDF has detected that the user is running RDF/IMP and the total number of physical
volumes for all UPDATEVOLUMEs exceeds 255. This can happen where some, or all, of the
UPDATEVOLUMEs are SMF virtual disks.
Effect RDF will not start.
Recovery Upgrade the RDF software to RDF/IMPX or reconfigure your disks on the RDF
backup node so that the total number of physical disks for all the UPDATEVOLUMEs is less
than 255.
The PURGER must be a named process
Cause You must specify a process name for the purger process before issuing an ADD
command.
Effect The start command fails.
Recovery You must reconfigure RDF with a named purger process.
RDFCOM Messages 423